How to organize prior environmental reports without assuming they remain sufficient
A practical guide for commercial real estate sponsors on reviewing, dating, and supplementing prior Phase I reports to support a financing request, including a concrete evidence checklist and worksheet.
A practical guide for commercial real estate sponsors on reviewing, dating, and supplementing prior Phase I reports to support a financing request, including a concrete evidence checklist and worksheet.
When a sponsor has prior environmental reports from an earlier acquisition or refinancing, it is tempting to treat them as current. But a Phase I environmental site assessment is a snapshot of the property at a specific moment, and lenders, along with their environmental consultants, will expect the report to meet the standard in effect at the time of the new financing. The goal is not to discard old work but to organize it so that the lender can see what is still valid, what has changed, and what gaps have been closed.
Identify the standard and date of each prior report
Start by recording the date of each prior Phase I and the standard it followed. ASTM E1527 has been updated several times; the current version is E1527-21. A report prepared under an earlier version may still contain useful historical research, but the lender’s environmental reviewer will likely ask whether the inquiry meets the current AAI Final Rule at 40 CFR Part 312. The EPA states that ASTM E1527-21 is consistent with the requirements of the final rule and can be used to satisfy the statutory requirements for conducting all appropriate inquiries . If your prior report used an older ASTM standard, you should ask the environmental professional who prepared it whether an update or a new Phase I is needed. A suggested way to prepare this information is to create a simple table listing each report, its date, the ASTM version cited, and the environmental firm that prepared it.
Check whether the property use or physical setting has changed
A Phase I includes a records review and a site reconnaissance. If you have made physical changes to the property since the last report, such as new construction, demolition, or changes in tenant use, those changes may create new recognized environmental conditions. The site reconnaissance section of a prior report may describe limitations such as snow-covered ground or limited access . If those limitations have since been resolved, the lender may consider whether a new inspection is needed. Record any changes in use, new tenants that handle hazardous substances, or any spills or releases that have occurred since the last report. The lender will want to know whether the prior reconnaissance still reflects current conditions.
Review data gaps from the prior report
The AAI Final Rule requires that the report document and discuss significant data gaps that affect the ability of the environmental professional to identify conditions indicative of releases or threatened releases . If the prior report identified data gaps such as an inaccessible area, missing historical records, or an inability to interview a key person, those gaps remain unless they have been filled. Identify each gap and note whether you have since obtained the missing information. If you have not, the lender may require a supplemental investigation. A concrete workpaper to prepare is a data gap tracker that lists each gap from the prior report, the date it was noted, and what action has been taken.
Confirm whether the prior report included a user questionnaire
The AAI process requires information from the user, which is typically the prospective landowner or borrower. This information may include title records, information of recorded environmental cleanup liens, recorded activity and use limitations, specialized knowledge, and the relationship of the purchase price to the fair market value of the property if it were not contaminated . If the prior report did not include a completed user questionnaire, or if the user has changed, the lender may require one. Ask the environmental firm whether a user questionnaire was completed and whether it remains accurate. If not, prepare a new one.
Assemble the prior report with any supplemental investigations
If the prior Phase I led to a Phase II investigation, such as soil or groundwater sampling, include that report as well. The lender will want to see the full chain of environmental diligence. Do not assume that a Phase I that found no recognized environmental conditions is sufficient if a later event, such as a spill or a change in adjacent property use, has occurred. The conclusions section of a Phase I typically includes a statement that the assessment has revealed no evidence of recognized environmental conditions . That statement is only valid as of the date of the report. If the property is still in the same condition and no new information has emerged, the prior report may still be useful, but the lender will decide whether it is current enough.
Prepare a current rent roll and operating statements for the property
While environmental reports focus on physical conditions, the lender will also need financial information about the property. For an existing property, have a current rent roll and trailing twelve months of operating statements ready [1]. These documents help the lender understand the property’s income and expenses. A suggested way to prepare is to have these documents organized and available alongside the environmental reports.
Organize the sponsor’s financial and entity information
The lender will also require financial statements for the principals and guarantors, organizational documents for the borrowing entity, and a schedule of real estate owned [1]. Have these ready alongside the environmental reports. The environmental diligence and the financial diligence are reviewed together, and a gap in either can slow the process. A suggested way to prepare is to create a single folder or index that lists every document by category, with dates and notes on any updates needed.
Frequently asked questions
Do I need a new Phase I every time I refinance? Not necessarily, but the lender will evaluate whether the prior report meets the current ASTM standard and whether property conditions have changed. If the report is more than a few years old or if there have been physical changes, the lender may require an update or a new Phase I.
Can I use a Phase I prepared for a previous owner? The AAI process is designed for the prospective purchaser or landowner. A prior owner’s report may contain useful historical information, but the user questionnaire and the liability protections under CERCLA are specific to the party conducting the inquiry. The lender will likely require a new Phase I or a reliance letter from the environmental firm.
What if the prior report identified a recognized environmental condition? That does not automatically prevent financing, but the lender will want to see what has been done to address it. Provide any remediation reports, closure letters, or ongoing monitoring plans. The lender may also require additional investigation or a carve-out for environmental liability in the loan documents.
To discuss how your property’s environmental reports fit into a financing request, send the property address, a brief description of the business plan, and the amount and timing you are considering to contact@wraithre.com.
Run the numbers on your deal
Try your own NOI, value and lender tests to see which one limits the loan: DSCR, LTV or debt yield.
Talk through your financing
Working on a real property? Send us the deal and a financing advisor will review it and get back to you. It costs nothing to ask and does not commit you to anything.
Requests are reviewed by Wraith Real Estate, a commercial real estate debt advisor (not a lender).